|
Still deciding? Get samples of $ !
Request Sample
|
| Customization: | Available |
|---|---|
| Carrier: | HDPE |
| Color: | White |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
HDPE is a white powder or granular product. Non-toxic, tasteless, crystalinity of 80%-90%, softening point of 125-1359c. usetemperature up to 100°c; hardness, tensile strength and creep are better than low density polyethylene, abrasionresistance.electrical insulation, toughness and cold resistance are beter, chemical stabilitly is good, at room temperature.insoluble in any organic solvent, resistant to corrosion of acid, alkali and various salts; film permeability to water vapor andair it is less resistant to aging and less resistant to environmental stress cracking than low-density polyethylene, especiallythermal oxidation will cause its performance to decline, so the resin must be added with antioxidants and ultraviolet absorbers toimprove the deficiencies in this regard, and high-density polyethylene film has a lower heat delection temperature under stress.
| Product name | HDPE 5502BN |
| Density | 0.955 g/cm3 |
| MFR(melt flow rate) | 0.35 g/10min |
| Yield tensile strength | 27 Mpa |
| Elongatlon at break | 600% |
| Flexural modulus | 1370 Mpa |
| Hardness | 63 |
1. inieclion mouldina producls, crales, bolle cans, barels, caps, food containers. trays, bins, boxes. and nlaslic fiowers.
2.Blow-moulding products. hollow moulding products, such as various series of blow-moulding barrels, containers, botles, holding
uelergenis, cnemicals, cosmeucs, elc, tanks, oallv necessllies, There are aiso blown nm prooucis such as 0od packading baas.
grocery shopping bags, fertiliser lining film.
3.Extruded plastic products: pipes and fitings are malnly used in Gas transmission, publlc water and chemical transmisslon, such
as building materials, drainpipes, gas pipes, hot waler pipes, etc.. Sheet is mainly used for seats, suitcases, handling containers
and so on.
4.Rotational moulding. injection moukding products such as large containers, storage tanks, barrels, boxes and so on.
5. polvethylene can be processed into fim, wire and cable sheathing, tubing. a variety of hollow products, iniection moulded
Droaucis, lores and so on, wdely used in aoncuure, packaoing, elecincal and electonic, machinen, automobles dalily
necessities and so on.
){kind=link}